Good day
I am busy with an upgrade endevour on our ECC 5 system. Braodly the steps that I have followed thus far are:
- System copy to a new server
- install and configure Solution Manager
- Run MOPZ and download siftware from Service Marketplace.
- Download SUM
I have now started and am running SUM (ST_Toolset) and reach a point in the process "Extraction - Initial Software Extraction" and am getting an error situation. When I look at the Trouble Ticket it says
"SAPup broke during phase INITPUT_PRE in module PREP_PRE_CHECK / Checks the system status
Error Message: The 'c' XUSER key for the DBM user does not exist or could not be identified."
I found note 39439 and tried commands:
C:\sapdb\programs\bin>xuser -U c -u CONTROL,control -d SID -n dsimsid001 -S INTERNAL set
C:\sapdb\programs\bin>xuser -u SAPservicesid -U c -u CONTROL,control -d SID -n dsimsid001 -S INTERNAL set
Where "SID" is my system id and dsimsid001 is the server. Please note that "SID" is in fact the system id. Both executed successfully but the error persists.
Can anyone give any information on what could be the problem here please?
Thanks and regards
Ray Phillips